Installation Guide for IGT
I-Game (I-Plus) Upright

Prepare Machine for Installation

Perform any audit, operational and/or security procedures required to open machine door.
Open machine and turn off all power
Remove Main Payout Hopper
Remove monitor if installing candle LED

Prepare Support Parts


Lay out parts		Disconnect Receiver from harness assembly. Locate interface cable and unplug candle LED adapter

Legs and Brackets


Install left leg, screw and tighten. Left leg has bracket and is mounted nearest connector		Install right leg, screw and tighten Channels face inward

Install hook bracket, screw and tighten. Note location of hook bracket to PCB		Install hole bracket, screw and tighten

Front Support Bracket


Remove Lanyard		Using lanyard hole install bracket, replace lanyard and tighten

Using the bracket as a template, drill hole, use screw and tighten		Repeat step 3

Candle LED installation


Install LED in candle and route wires downward behind reels/monitor to payout hopper		Insert candle LED wires into adapter #5 Hole – Green, #6 Hole – Red, #9 Hole - Orange

Install Transmitter and Receiver


Separate Probe assembly and transmitter Power Cable Blue wire to probe, Black wire to ground washer		Install transmitter onto mounting bracket. Please note location of PCB

Transmitter and Receiver


Unscrew/ Insert transmitter onto 19 pin plug on payout hopper, re-tighten screws		Slide receiver/bracket onto 19 pin plug

Install Hopper Probes


Probe should be inserted using the lowest pre-existing hole on the hopper. If not applicable, hole must be drilled		Position ground washer location low and flat, drill hole and tighten

This represents a typical probe and ground washer locations Run probe wires underneath hopper from power

Transmitter Power Connection


Connect Transmitter Power Cable to PCB		Connect Transmitter Power Cable to Transmitter Assembly

Transmitter Power Cable Exceptions


If this connection is not available, you will need the following >		12 or 16 pin

Power Connections


Connect power supply to available outlet with extension if needed		Connect power supply to controller PCB

Connect Receiver to extension from Controller PCB		Connect interface cable to candle LED

Install Support Structure


Please make sure legs are straight and evenly spaced Insert hook bracket into opening, screw and tighten hole bracket into pre-drilled front bracket hole.

Install Attendant Hopper


When inserting Attendant please pull up on stop to insert fully.

Re-install Hopper and Fill Both Units