Installation Manual for IGT
S+ PE+ Slant Tops

Prepare Machine for Installation

Remove Coin Chute and Hopper

Install Mounting Brackets

Unpack and Install Probes


Disconnect Power Cable from Assy

Install Hopper Probe and Ground Washer


Use washer as a drill template \| Use lower hole if applicable

On Payout Hopper


Remove 19 pin plug from payout hopper		Install the Transmitter Bracket onto plug using existing hardware

Install Ground and Connect Power Cable


Connect the Attendant Power Cable “Green” wire to ground		Disconnect “Red” hopper cable and attach Attendant Power Cable

Transmitter and Receiver


Re-Connect Power Cable to Attendant transmitter Cable		Install Receiver Bracket onto 19 pin plug

Candle LED and Power


1 Route Candle LED, wiring through opening in machine, to top box for installation. 3 Tie wrap cables to machine sides avoiding tangle or cutting.

Install Attendant


1 Connect receiver cable to Controller PCB		2 Plug in power to Attendant
3 Slide Attendant onto attached brackets and tighten

Ready for Operation


Fill coins in Attendant making sure coins are touching both contact areas, LED’s will be green

Please Note


For machines prior to 1992 – with a locking latch installed on the left side of the door. A separate drill template may be needed to re-locate (locking latch) to right side of door, to avoid any clearance issues.

Warranty and Reference

Warranty, Electrical and Technical Information can be found in any
S+ Upright Manual.

Thank you, enjoy our product!